R1Soft : An error occurred while loading the hcpdriver module

R1soft CDP backup allows for full server backup and you can use it to perform the bare metal restoration.

If you have upgraded Kernal version on your server then you might face the following error while running the backup.

An exception occurred during the request. The replication driver was not detected (detail: An error occurred while loading the hcpdriver module, please check your system logs; Please run “r1soft-setup –get-module ” on your Agent to install one.

 

Run the following command to load the hcp driver.

lsmod | grep hcp

If it returns with no value, this means hcp driver is not installed on your machine so proceed with the below steps.

  1. You will need to verify the kernel version.

uname -r
  1. Now, Verify Kernel-devel & Kernel-headers packages. It should match with installed Kernel version.

rpm -qa | grep kernel
  1. Install the matching version, if it is not installed. Run the following command for this.

r1soft-setup --get-module
r1soft-setup --get-module --no-binary
  1. Restart the CDP agent once.

/etc/init.d/cdp-agent restart
  1. Run the following command to load the hcp driver again.

lsmod | grep hcpdriver

You will see the value in return. Backup should be run fine using R1Soft now.

  • 0 Users Found This Useful

Was this answer helpful?

Related Articles

How Do I Point My Websites to VPS?

This article will guide you to point your websites to VPS. You can point your websites to VPS in...

How to Install and configure Dovecot on CentOS?

Dovecot is used to receive incoming emails on your server from Postfix. Dovecot is an open-source...

how to configure SSH key-based Authentication in Linux VPS or Dedicated Server

This article will guide how to configure SSH key-based Authentication in Linux VPS or Dedicated...

How Do I Check Bandwidth Utilization of VPS?

Windows VPS To check/monitor usage of each Windows VPS, we have installed bandwidth meter tool...