R1Soft : An error occurred while loading the hcpdriver module

R1soft CDP backup allows for full server backup and you can use it to perform the bare metal restoration.

If you have upgraded Kernal version on your server then you might face the following error while running the backup.

An exception occurred during the request. The replication driver was not detected (detail: An error occurred while loading the hcpdriver module, please check your system logs; Please run “r1soft-setup –get-module ” on your Agent to install one.

 

Run the following command to load the hcp driver.

lsmod | grep hcp

If it returns with no value, this means hcp driver is not installed on your machine so proceed with the below steps.

  1. You will need to verify the kernel version.

uname -r
  1. Now, Verify Kernel-devel & Kernel-headers packages. It should match with installed Kernel version.

rpm -qa | grep kernel
  1. Install the matching version, if it is not installed. Run the following command for this.

r1soft-setup --get-module
r1soft-setup --get-module --no-binary
  1. Restart the CDP agent once.

/etc/init.d/cdp-agent restart
  1. Run the following command to load the hcp driver again.

lsmod | grep hcpdriver

You will see the value in return. Backup should be run fine using R1Soft now.

  • 0 Users Found This Useful

Was this answer helpful?

Related Articles

How to create users and groups in CentOS7?

Once the Linux system is configured, adding and removing users is one of the most basic tasks...

How To install Nginx on CentOS 7?

Nginx is a Web server that can be installed on Linux Server. You may have heard about Apache Web...

how to configure SSH key-based Authentication in Linux VPS or Dedicated Server

This article will guide how to configure SSH key-based Authentication in Linux VPS or Dedicated...

How to check Various cPanel logs like WHM, Apache, MySQL, Email, Error etc?

You can use cPanel to access your Linux hosting account with GUI. It is relatively easier to work...

How to add IP address in Ubuntu using command?

Sometimes you may require to add the IP Address manually in ubuntu network Interface. Following...