Fix :: Error 126 while starting remote desktop service, the specified module could not be found

Problem Statement


Could not connect to Windows VPS


Error Message


Remote Desktop can't connect to the remote computer for one of the reasons

  1. Remote access to the Server is not enabled
  2. The Remote computer is turned off
  3. The Remote is not available on the network


Solution


We logged in this VPS through HyperVisor console and attempted to start the Remote Desktop service, we received following error:

Error 126 while starting remote desktop service. The specified module could not be found

  1. Login to VPS through console.
  2. Open command prompt by Start → Run → Type cmd Hit Enter.
  3. Type command run sfc /scannow and Hit Enter.
  4. Once task is completed try to start Remote Desktop service again.




Related Articles

How to Enable Ping/ICMP Echo Request in Windows Server?

PING or ICMP Echo Request is the most common network troubleshooting tool to determine whether...

How to install Node.Js on Windows Server?

Following steps will be helpful to install Node.Js on your windows server. Go to...

How To Setup SMTP in nopCommerce to Send Email?

Login to your nopCommerce admin with URL yourdomain.com/admin Click on Configuration >>...

How to block single IP address or range of IP addresses from Windows Firewall 2008?

Following article will assist you to block single IP address or a range of IP addresses in...

How to reboot my Windows VPS from VPS Management Portal?

You can reboot your VPS from your VPS Management Portal (https://cp1.accu15.com) by following...

  • 0 Users Found This Useful

Was this answer helpful?